Retrofit installation

Fit around what’s already there.

A two-piece component for an installation where the cables were already in place.

Two-piece cable-entry collars fitted around existing cables beneath an electrical enclosure — Retrofittable cable-entry collars

Project: Retrofittable cable-entry collars
Scope: Design + manufacture
Material: ASA

The challenge

Conventional one-piece components were impractical once cables had been installed. The design needed to accommodate the existing cables and the available fitting access.

The approach

Custom interlocking collars were developed in two pieces so they could be assembled around each cable without disconnection. The components were manufactured in ASA for this application.

The practical value

The split geometry addressed the installation constraint directly: fit the component around the cable, rather than disconnect the cable to fit the component.

Discuss a similar challenge

UP NEXTReinforcement-bar spacers

A part. A problem. A possibility.

Let’s work out what’s next.

Discuss your project